Minolta-QMS magicolor 2300 DL :  foo2zjs - foo2hp - foo2xqx - foo2lava - foo2qpdl - foo2oak
Support for linux printer drivers
The fastest message board... ever.
 

Current Page: 1 of 1
Results 1 - 4 of 4
8 years ago
soub
Rick, I found the solution, you were right. The printer needed a roller and sensor cleaning, this is the reason for the random 1 inch offset. I would advice to anyone for reading the maintenance manual. Than you,
Forum: Minolta-QMS magicolor 2300 DL
8 years ago
soub
The testpage was printed 1" below the upper sheet border. Sheet dimensions are perfect. It is just the impression that is offset 1" below that it should be (this time a used a rule to check dimensions). In WinXP the impression is Ok. What you mean by repairing the 2300DL? I am thinking to change the upper offset: -u xoffxyoff: Set the offset of the start of the printable region f
Forum: Minolta-QMS magicolor 2300 DL
8 years ago
soub
This command gives the following output: Sep 9 01:19:26 MyMachine foo2zjs-wrapper: foo2zjs-wrapper -r1200x600 -p1 -m1 -s7 -d1 -GDL2312.icm -I0 Sep 9 01:19:28 MyMachine foo2zjs-wrapper: gs -sPAPERSIZE=letter -g10200x6600 -r1200x600 -sDEVICE=pbmraw -dCOLORSCREEN -dMaxBitmap=500000000 Sep 9 01:19:28 MyMachine foo2zjs-wrapper: foo2zjs -r1200x600 -g10200x6600 -p1 -m1 -n1 -d1 -s7 -z0 -u 204x10
Forum: Minolta-QMS magicolor 2300 DL
8 years ago
soub
Hello, I have problems for adjusting the printing margins in the printer. The paper is printed 1.3' lower than it should be, and it is also a little bit wider than 8.5' (for a letter size paper). Is there any workaround? Best Regards, soub
Forum: Minolta-QMS magicolor 2300 DL
Current Page: 1 of 1

This forum powered by Phorum.