Just wondering, is there any possibility to get at least some control over how much toner is applied when printing?
I'm using the CLP-365 for toner transfer. Since samsung's toner is somewhat a good dielectric, and grips onto the copper hard. I want to use it to create solder masks and silkscreens for my DIY PCBs. However unlike ML-2167 I used before, this one is very greedy, and the results are lower quality.
Obligatory examples for comparison:
Created with ML-2167, one layer of toner, 600x600dpi: http://ncrmnt.org/wp/2014/01/18/toner-trasfer-double-the-sides-double-the-fun/
Created with CLP-2167,
one layer of toner 1200x600dpi (Blue): http://pics.ncrmnt.org/index.php?album=junk/colorsilk
Green: 2 layers, printed twice on the same sheet of paper.
Edited 2 time(s). Last edit at 09/14/2014 12:52PM by rickrich.